Kopp INFRAcontrol T 180 UP IP40 Mode D'emploi page 20

GB
Setting the duty cycle (switch-off delay)
Carefully open the front cap, set the sliding switch
AUTO position.
► Set the desired duty cycle
Seven time settings are possible: approx. 5 sec. /
approx. 20 sec. / approx. 1 min / approx. 5 min /
approx. 15 min / approx. 30 min. / test
► Test mode :
8
Consumers and internal LED
and OFF for 2 seconds.
The listed duty cycles are approximate values and are subject
to technical deviations.
20sek.
Fine sensitivity settings
9
5sek.
Carefully open the front cap.
to the AUTO position.
Set the sliding switch
6
Fine adjustment of the range detection with the "METER"
adjustment screw between the positions "-" and "+".
"-" smallest possible detection range (≈ approx. 1 m)
"+" largest possible detection range (≈ approx. 9 m)
20
:
8
blink ON for 2 seconds
10
1min.
5min.
15min.
30
Test 30min.
Zeit
8
to the
6
20sek.
5sek.
9
100 300
5
1min.
5min.
15min.
Test 30min.
Zeit
100
300
30
Meter
5
10
30
5