Filling Fuel - Planika FLA3 Notice D'utilisation

1. Open the control panel and fuel inlet (I) and turn the device ON by pressing
2. If the tank is empty (NO FUEL) or you want to fill the fuel, open the fuel inlet (I) and firmly connect
the pump hose 'a' (click!) and power cable 'b' (II) (REFUELLING, PLEASE WAIT).
I
3. Place the fuel container stably on the floor and insert the pump hose 'c' (III). Press and hold the button
on the pump to start refuelling (IV).
III
Once the fuel container has been emptied, replace it with a full one and start the pump again (see point 3).
The pump will stop when the tank is full (sound + RESERVOIR FULL)
4. Disconnect the power cable 'b'. To disconnect the pump, hold the end of the hose 'a' and firmly press the plate
in the place marked with a sticker (V). Close the fuel inlet.
5. Shake the remaining fuel from the hose 'c' to the container and place the pump in the bag (VI).
Message READY indicates that the device is ready to ignite the flame.
Press START. Flame ignition will take 2-10 minutes (PLEASE WAIT). The smell of ethanol vapours can be present
during the ignition. The message WORKING indicates that the flame has been ignited and the device reached the
working temperature.

FILLING FUEL

c
b
a
V
FLAME IGNITION
a
b
II
IV
VI
5
.