Uberhaus 70005007 Mode D'emploi page 42

7. Right side Shelf Assembly
Use four 5/32-in. x 10-mm Truss Head Screws and four 5/32-in Locking Washers to assemble the
Triangle Bracket, Right to the bottom rear of Side,Burner Shelf and Cart Leg, Back Right.As shown in Fig
13.
8. Side Burner Installation
a) Open side burner lid and place the Side Tube Burner (U) through the opening.
Place the Side Tube Burner (U) tube over the side burner gas valve and make sure Side Burner
gas valve is inserted into side burner tube. As shown in Fig.14. Then with two 5/32-in. x 10mm
Truss Head Screws (AA) and two 5/32-in. Locking Washers (BB) secure the side burner from
underneath to the Side Burner Shelf (D). As shown in Fig. 14.
b) Connect ignition wire from BBQ body (A) control panel to the side burner igniter pin from
underneath the Side Burner Shelf & Control Panel (D).
Note: After completing side burner installation, make sure
there is no more than a 3 mm gap between igniter pin and
burner.
PDF 文件使用 "pdfFactory Pro" 试用版本创建
D
14
www.fineprint.com.cn
Fig. 13
U
Fig. 14
BB
AA