Assembly - Greencut GLM880X Manuel D'utilisation

82

ASSEMBLY

ATTENTION: The lawn mower is supplied without fuel and oil in the engine. Your new lawn mower
has been tested at the production site which means that the engine can contain a small amount
of residual oil.
ASSEMBLY OF THE HANDLEBAR
1. Insert the bottom of the handlebar into the appropriate hole and secure it with the screws and knobs.
2. Insert the top of the handlebar so that the holes match. Secure the handlebar by placing and adjusting the
lock/unlock knobs and levers.
3. Disconnect the cable from the locking lever by unscrewing the lever from the handlebar.
4. Pass the cable through the slot in the control panel, snap the locking lever onto the handlebar, and then
reconnect the cable.
Screw
1
PLACE THE CONNECTING CABLE
Fix the connection cable to the handlebar with the supplied clamps.
Lever
2
Tweezers
4