Assembly - Greencut GLM580X Manuel D'utilisation

ASSEMBLY

ATTENTION: The lawn mower is supplied without fuel and oil in the engine. Your new lawn mower
has been tested at the production site which means that the engine can contain a small amount of
residual oil.
ASSEMBLY OF THE HANDLEBAR
1. Carefully unfold the mower's handlebars, taking care not to pinch or damage the machine's control cables.
Position the lower handlebar by aligning the side holes with those on the mower at the back of the cover.
2. Place the plastic tube spacer on both sides so that the curved section is positioned against the handle tube.
3. Place the lower handlebar bar locking handles on the outside and secure them until they are tight.
4. To secure the upper handlebar, first remove the two handlebar locking handles. Place the upper handlebar
on the lower bars, aligning the holes in the upper handlebar with the holes in the lower handlebar. Insert the
two locking handle screws through the lower handlebar and then through the holes in the upper handlebar.
5. Once the screws are in place, place the handlebar bar locking handles on the outside of the upper handlebar
and secure them until they are tight.
2
ASSEMBLY OF THE COLLECTION BASKET
Attach the plastic basket clips to the mower's metal frame. Make sure these clips are fully secured to the frame.
3
Basket cover
Frame
4
Basket
75
5
EN