brennenstuhl SL DN 2405 IP44 Mode D'emploi page 6

Operating Instructions
D
MOuNTINg THE LED LIgHT ON THE TrIPOD
E
a
B
Put up the tripod first. To do so, push the clamping pin on the hinge (C) upwards and unfold
the foot at the same time. When the foot is unfolded, the clamping pin will automatically click
into place again.
In order to adjust the tripod height, loosen the pipe clamping nuts (B), pull out the tripod pipes
up to the desired position and tighten the nuts again.
Attach the LED lamp to the tripod with the mounting screw (A), using the center hole of the
mounting bracket. As for the double lamp, mount the crossbar to the tripod using a star knob
screw (A), and then mount the two lamp with 2 star knob screws (A) to the crossbar.
To adjust the tilt angle of the lamp, loosen the screws on both sides of the holder, readjust the
lamp's position and tighten the screws.
To safely store the connecting cable whenever it is not in use, roll it up around the cable
holder (D).
6
BA_SMD-LED-Leuchte mit Stativ_0489072-16P024_160929.indd 6
E
f
a Star knob screw
B Pipe clamping nut
c Hinge
D Cable holder
E Light
f Crossbar
D
c
SMD-LED-Light with Tripod
a
B
E
a
D
c
29.09.16 12:21