Installation And Connection; Remedy Of Faults - Oase LUNAQUA 3 Halogen Notice D'emploi

Installation and connection

B
• Install the transformer at least 6.6 ft (2 m) from the edge of the pond.
• Position the unit in such a way that it does not present a hazard to anyone.
• Ensure safe and stable seating. Ensure the sufficient load carrying capacity of the wall or ground for installation on
the wall or on the base.
• For installation above water: Ensure a safety distance of at least 1.7 ft (50 cm) from combustible material. Fire
hazard: Do not cover the unit!
Wall or ground installation
C
• The base foot can either be placed on the ground or bolted to a firm base or load bearing wall.
Tilting the unit
E
• Turn the holding screw counterclockwise and tilt the unit as required. To fasten in place turn the holding screw
clockwise.
Connect the unit
Attention! Operate the unit at all times with the safety transformer UST 150 from OASE or a different power supply
unit meeting the safety requirements.
Start-up
Attention! Sensitive electrical components.
Possible consequence: The unit will be destroyed.
Protective measure: Do not connect the unit to a dimmable power supply.
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
• Before reaching into the water, disconnect all units located in the water from the mains.
• Disconnect the unit from the mains before performing any work on the unit.
• Secure the unit to prevent unintentional switching on.
Switching on: Insert the power plug of the transformer into the socket.
• Check the function of the spotlights.
Switching off: Disconnect the transformer power plug.

Remedy of faults

Malfunction
Lamp does not light up
Luminosity decreases
Water inside the spotlight housing
S
22752-11-13_GA_LunAqua 3 Halogen5 5
Cause
Power supply interrupted
Bulb defective
Lamp glass soiled
The brightness of the bulb reduces as the
operating time increases
Seal defective
- English -
Remedy
Check power supply
Replace bulb
Clean
Replace bulb
Check sealing rings and replace, if necessary
12.11.2013 11:42:48
5