Electronic Equipment - EdilKamin FLEXA Installation, Usage Et Maintenance

REMOTE CONTROL code 658830 - optional
SYMBOLS KEY
Note: depending on the production lots, two different symbols for the power button may be used ( (X - see fig. 1-2)
: ignition / shutdown button
+ : button to increase the power/operating temperature
-
: button to increase the power/operating temperature
A : "AMBIENT" button; changes the desired ambient temperature (SET AMBIENT TEMP. )
P (fig. 1) M (fig. 2)
: "POWER" button; modifies the power (from P1 to P5)
- the remote control transmits by means of an infrared signal within a range of 4-5 metres.
The LED transmission signal must be in line with the receiving LED of the stove for the signal to be transmitted correctly. This
must also be in a free-field environment, therefore, free of obstacles.
- The remote control works with 3V battery. Battery duration depends upon usage, however, the average duration is that of an
entire season.
To replace the battery, remove the door, Y, where the battery is housed.
The discharged battery should be properly disposed of in accordance with current regulations in force.
- the remote control must be cleaned with a damp cloth and no detergents or liquids must be sprayed onto it. In any case, use
neutral detergents which are free from aggressive substances.
- handle the remote control with care. It could easily break if dropped, due to its size.
NOTES:
- Operating temperature:
- Storage temperature:
- Operating humidity is:
- Degree of protection is:
- Weight with battery inserted:

ELECTRONIC EQUIPMENT

(X)
fig. 1
Y
0-40 °C
-10/+50°C
20-90% R.H with no condensation
IP 40
15 gr
(X)
fig. 2
Y
- 26
-