EdilKamin FLEXA Installation, Usage Et Maintenance page 22

1
5
N
N
2
N
N
3
fig. 1
fig. 2
N
fig. 3
fig. 4
ASSEMBLY
4
1
5
N
N
2
N
N
3
V
Z
5
L
L
M
COVERING
Parts list (see fig. 1)
• 6 ceramic side tiles (1-2-3)
• ceramic top (4)
• 2 aluminium rear sides (5)
• ceramic tile fastening kit
For assembly proceed as follows:
- Lift up the cast iron top, loosen the screws (V) and remove
the two
aluminium rear sides (5) unhooking them from the
fixing pins (Z) located on the cast iron base fig. 2
- On the rear, apply the ceramic panels (1-2-3) and the plates
(N) securing them in the holes provided using the screws sup-
plied (fig. 3).
Due to production characteristics, the ceramic panels, made
from castings, may be slightly different in height; To remedy
any possible difference in height, use the rubber pads supplied,
which do not affect the stove's aesthetics in any way.
Place the rubber pads and the gasket between the cast iron base
and the lower ceramic panel (3), while inserting only the rubber
pads supplied between ceramic panels (3-2-1).
- Place each ceramic element up against the side, aligning
the grooves (L at the end of the front edge) on the structure's
vertical profile made of toothed sheet metal.
- Secure the ceramic panels with the plates applied to the
stove's structure, inserting the screws and the washers supplied
in the holes provided (fig. 5)
- Reassemble the two aluminium rear sides (5).
- Position the ceramic top (4) in the grooves.
(S-fig. 6).
Note: In the version with sheet metal covering, the stove
is supplied already assembled, except the ceramic top which
must be positioned in the special grooves (S-fig. 6).
fig. 5
4
fig. 6
- 22
-
N
S
S