Optional Accessories; Parts List - England's Stove Works 17-VL Manuel D'installation Et D'opération

Masquer les pouces

Table des Matières

Les langues disponibles

Diagram

Not Shown

AC‐16 Convection Blower

The Tranquility wood stove was also designed for use with a convection blower for

additional heat circulation. The stove is constructed with rear and top convection channels

which allow the room air blower to pick up heat from the hottest regions of the stove and

transfer it into the home. The mounting screws for the blower are installed into the rear

convection channel at the factory; mounting the blower only requires a 5/16" open end or

socket wrench to remove these screws and install the blower. When routing the power cord,

take care to keep away from hot areas of the unit and remember that this blower is for use only

with the stove. Please see the diagram below for clarification on the room air blower

installation.

(4) 5/16" head, self tapping

screws (pre‐installed in unit).

The optional heat circulation blower on this stove requires periodic lubrication; this lubrication

should be performed no less than every three months of normal operation. To properly lubricate the

blower, use an eye dropper or similar dispensing device to drip 5-7 droplets of SAE 20 oil into the

Page | 24

oil port on the side of the blower motor.

REPLACEMENT PARTS LIST

Description

No.

Air Control Slider

Outside Air Adapter

Right Vermiculite Panel

Left Vermiculite Panel

Rear Vermiculite Panel

9" x 4" x 1.25" Firebrick

Top Vermiculite Baffle

Door Gasket [5/8" dia HD]

Window Gasket

Ceramic Glass Panel

Window Retaining Brackets

Cast Iron Door

Secondary Tube (Front)

Upper Refractory Baffle

Secondary Tube (Rear)

Large Spring Handle

Air Control Spring Handle