HP ProLiant Manuel page 247

Modification de position de disque
détectée 160
Modification de taille de mémoire
d'accélérateur RAID détectée
1726-Slot X Drive Array - Array
Accelerator Memory Size
Change Detected. - ... 160
1726-Slot X Drive Array - Cache
Memory Size or Battery
Presence Has Changed 160
Module batterie d'accélérateur
RAID
1732-Slot X Drive Array - Array
Accelerator Battery Pack
Missing... 160
1793-Drive Array - Array
Accelerator Battery Depleted -
Data Lost. (Le message
d'erreur 1794 s'affiche
également). 179
1794-Drive Array - Array
Accelerator Battery Charge
Low... 179
Module d'accélérateur RAID 170
Module d'alimentation 181
Module d'alimentation du
processeur (PPM)
Problèmes de module
PPM 44
Problèmes de processeur 2
Module RAID
1785-Slot X Drive Array Not
Configured... 175
1786-Slot 1 Drive Array
Recovery Needed... 176
1786-Slot 1 Drive Array
Recovery Needed. Automatic
Data Recovery Previously
Aborted!... 176
1787-Drive Array Operating in
Interim Recovery
Mode... 177
1788-Slot X Drive Array Reports
Incorrect Drive
Replacement... 177
Module RAID non configuré 175
Modules DIMM
207-Invalid Memory
Configuration Detected.
DIMMs installed when no
224 Index
corresponding processor is
detected. 147
207-Invalid Memory
Configuration - DIMM Size
Parameters Not
Supported. 147
207-Invalid Memory
Configuration - DIMMs must be
installed in pairs or
sequentially 147
207-Invalid Memory
Configuration - DIMMs Must be
Installed Sequentially 147
207-Invalid Memory
Configuration - Mismatched
DIMMs within DIMM
Bank 147
207-Invalid Memory
Configuration - Mismatched
DIMMs within DIMM
Bank... 147
207-Invalid Memory
Configuration - Unsupported
DIMM in Bank X 147
207-Invalid Memory
Configuration - Unsupported
DIMM in Socket X 147
207-Memory Configuration
Warning - DIMM In Socket X
does not have Primary Width of
4 and only supports standard
ECC. 147
209-Invalid Lockstep memory
configuration 147
Instructions sur la manipulation
des modules DIMM 5
Invalid memory types were
found on the same node.
Please check DIMM
compatibility. - Some DIMMs
may not be used 133
Memory found on unpopulated
Node. ? Le processeur doit
être installé pour pouvoir
utiliser la mémoire. 133
Parity Check 2 - System DIMM
Memory 133
There must be a first DIMM in
pair if second DIMM in pair is
populated. Second DIMM in
pair ignored. 141
This DIMM does not support
thermal monitoring... 141
Unsupported DIMM(s) found in
system. - DIMM(s) may not be
used 141
Mot de passe non valide
Invalid Password - System
Halted! 133
Invalid Password - System
Restricted! 133
Mots de passe
Invalid Password - System
Halted! 133
Invalid Password - System
Restricted! 133
N
Niveau de performance enfreint
pour le disque
SCSI Port X, Drive ID Y Has
Exceeded the Following
Threshold(s) 120
Warning Bit Detected 126
Notifications de service
Notifications de service 15
Notifications de service et
avis 101
Nouveau matériel 40
Nouveautés 1
Novell NetWare
NetWare tente de charger
MEGA4 XX.HAM ou
120PCI.HAM pendant
l'installation, et une carte
RILOE II est installée 70
Systèmes d'exploitation Novell
NetWare 205
Numéro de série 78
Numéros de téléphone 52
O
Onduleur
L'onduleur ne fonctionne pas
correctement 39
Problèmes d'onduleur 38
FRWW