Whirlpool W84TE72X Mode D'emploi page 35

ERROR TYPE
SR – Set value
blink on cooler set
value screen
"--"
What to do if your refrigerator does not operate:
Check that:
• Your fridge is plugged in and switched on,
• The fuse is not blown and there is not a power cut,
• The thermostat setting is in the on the "1" position,
• The socket is no longer functioning. To check this, plug in an appliance that you know is working
into the same socket.
What to do if your refrigerator performs poorly:
Check that:
• You have not overloaded the appliance,
• The doors are fully closed ,
• There is no dust on the condenser,
• There is enough space for air circulation at the rear and side of the appliance.
If your fridge is operating too loudly:
Normal Noises
Cracking (Ice cracking) noise:
• During automatic defrosting.
• When the appliance is cooled or warmed (due to expansion of appliance material).
Click noise: Heard when the thermostat switches the compressor on/off.
Compressor noise:
• Normal motor noise: This noise means that the compressor is operating normally
• The compressor may cause more noise for a short time when it is first activated.
Bubbling noise and splash: This noise is caused by the flow of the refrigerant in the tubes of the
system.
Water flow noise: Normal flow noise of water flowing to the evaporation container during defrosting.
This noise can be heard during defrosting.
Air blow noise (Normal fan noise): This noise can be heard during the normal operation of system
due to the circulation of air.
If humidity builds up inside the fridge;
• Is all the food packed properly? Are all containers thoroughly dried before placing them in the
fridge?
• Are the fridge doors opened frequently? Humidity of the room gets into the fridge each time the
doors are opened. Humidity build up will be faster if you open the doors more frequently, especially
if the humidity of the room is high.
• Build up of water drops on the rear wall after automatic defrosting is normal. (in Static Models)
If the doors are not opened and closed properly;
• Do the food packages prevent closing of the door?
• Are the door compartments, shelves and drawers placed properly?
• Are door gaskets broken or torn?
• Is your fridge on a level surface?
If the edges of fridge cabinet that the door joint contact are warm;
Especially in summer (hot weather), the surfaces that the joint contact may get warmer during the
operation of the compressor. This is normal.
MEANING WHY
The foods starts to
Refrigerator comp. freeze because of
too Cold the too much cold
temperature
When the power
supply gets lower
"Low voltage
than 170 V the
Warning"
appliance gets to
steady position.
EN - 35
WHAT TO DO
1. Check if the "Super cooling
mode" is on
2. Decrease the refrigerator
temperature values
This is not a failure. This
prevents any damages on
the compressor. This warning
will off after the voltage gets
required level