Brandt TV323BT1 Guide D'utilisation page 5

Connection
When the power is
code appears on the control panel. This disappears automatically after
about 30 seconds or
panel. This is normal, as the display is for use by the after-sales service when required. The user must not
take this into account under any circumstances.If the unit has a 3 phase 400 V2N connection, and is not
working correctly, check that the neutral wire is correctly connected. This precaution should also be taken
for all your other electronic apparatus.
"When installing the hob, precautions must be taken to avoid damaging the power cable with the sharp
edges"
4
3
2
1
Your hob must be connected to the mains with:
- A H05RRF type cable with three 2.5 mm² conduc-
tors or five 1.5 mm² conductors (including a yellow /
green earth wire)
- A plug that complies to CEI 60 083
recommendations or an all-pole circuit breaker with
contacts that open by at least 3 mm.
Installing your hob in complete safety
switched on, or after
as soon as any touch
220-240V
N
1
L1
2
3
4
You must use a 32
Amp fuse on your ins-
tallation
220-240 V∼ ∼ 50 Hz
Total energy consumption:
TV321.....5,6 kW
TV323.....6,6 kW
5
a long power failure,
control is touched
400V2N
1
L1
2
3
N
4
You must use a 16
Amp fuse on your ins-
tallation
a light
on the
L1
L2
N