Adjustments; Adjusting The Slide Plate Clamp; Repositioning The Wedge Adaptor - Vinten Vector 75 Manuel D'utilisation

English

Adjustments

After considerable use the slide plate clamp may require adjustment.
To enable the payload to be correctly balanced, the wedge adaptor may require
repositioning.
The pan and tilt brakes may require adjustment after considerable use.

Adjusting the slide plate clamp

(Fig 8)
The slide plate clamp [12] should be set so that in the up or clamped position it prevents the slide
plate from being moved, while in the down or released position it allows free adjustment of the
slide plate. To adjust the clamp, proceed as follows:
On the left-hand side of the platform, carefully remove the plastic cap [12.2] to reveal the
slotted shaft [12.1].
Pull the slide plate clamp lever [12] fully upwards.
Slacken the clamp screw [12.3].
Turn the slotted shaft [12.1] fully clockwise to apply the clamp.
Tighten the clamp screw [12.3].
Move the lever over its full range and ensure that in the clamped position it prevents the
slide from being moved, while in the released position it allows free adjustment of the
slide. Readjust if necessary.
Replace the plastic cap [12.2] over the slotted shaft [12.1].

Repositioning the wedge adaptor

(Fig 9)
The wedge adaptor [1] is secured by four cap head screws [3] which pass through the wedge
adaptor into the slide plate [14].
WARNING!
Overlong screws will prevent the slide plate from operating. Always use the
screws provided (M6 x 30 mm).
To reposition the wedge adaptor:
Engage the centre lock (see Locking the platform on page 11) and remove the load.
Hold the body of the wedge adaptor [1] and use a 4 mm hexagon wrench to remove four
securing screws [3].
Reposition the wedge adaptor [1] on the slide plate [14], ensuring that the narrow end
of the wedge adaptor faces forwards.
Insert the four screws [3] in the holes in the wedge adaptor and tighten.
14