Replacing The Brushes - Polaris 9300xi Sport Manuel Du Propriétaire

5.3 Replacing the Brushes

The cleaner is fi tted with PVC brushes. There are ''wear''
indicators on the brushes. To maintain cleaner perfor-
mance at its best you need to replace the brushes as soon
as one of the wear indicators has been reached (even if
the blade wear is not even). Zodiac Pool Systems, Inc.
recommends that you replace the brushes every two (2)
years.
1. Lift the cleaner to a vertical position so that the
handle is up. Refer to Figure 28.
1
Figure 28. Clean in Upright Position
2. Separate the edges of the brush and undo the tabs
as shown is Figure 29. Remove the worn brushes.
2
Figure 29. Undo the Tabs of the Brush
3. To install a new brush, position the new brush on
the roller with the spikes facing downwards. Refer
to Figure 30.
3
Figure 30. Install the New Brush
4. Thread each tab into the slot provided and gently
feed it through until the heel comes out at the
other side of the slot. Refer to Figure 31.
4
Figure 31. Pull Tabs Through Each Slot
5. Use a pair of scissors to cut the tabs 3/4 inch from
the heel so that they are no higher than the spikes
as shown in Figure 32.
6. Repeat this procedure to install the second brush.
Figure 32. Cut Tabs
Page 13