Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. INSTALLING THE DEVICE
(SEE FIG. 1)
Notes:
Do not route any wiring over circuit boards.
This Communicator shall be installed by qualified SERVICE PERSONS only, in the shelter of a
safe and dry site, away from radio-transmitting equipment.
Test the GSM Network reception before mounting this Communicator in the proposed
placement.
1.
Mark the position of the holes [19] required to fix the metal base [17] to the wall.
2.
Drill holes in the wall as marked.
3.
Insert the 4 PCB supports [16] into the holes on the metal base [27].
4.
Feed the connection cables through the opening on the base [22].
5.
Fix the metal base to the wall using wall anchors (not supplied).
Caution! Make sure you do not damage wiring or pipes in the chase.
6.
Position the electronic P.C.B. on the supports [16] and push it down until it clicks into position, as
illustrated in Figure 1.
7.
Connect the antenna cable [3] to the connector on the electronic PCB [4].
8.
Feed the antenna cable [3] the cable clamp tab [26], then through the opening [23].
9.
Position the antenna [1] on the upper edge of the base so that the magnetic base [2] adheres to the
surface.
Note:
The antenna may be positioned on the top edge of the base, at the point most suited to receiving
the GSM signal.
10. If necessary, fit the MAXIASNC anti-tamper switch [15] (optional) to the pins as illustrated in Figure 1.
Note:
The switch lever must be directed as illustrated in Figure 1, otherwise the device will not work
correctly.
11. Perform the terminal block connections [10] as described in par. "Connecting the device" and, if necessary,
connect the anti-tamper switch (for connecting the tamper switch see the "Connecting the device-
>Auxiliary connections" section).
12. Following the arrow, insert the SIM-CARD [8] face down in the SIM holder [6] (see Figure 1).
CAUTION! The SIM-CARD PIN must be disabled before the card is inserted into the Communicator.
CAUTION! It is recommended that you disable call forwarding on your SIM card.
13. Make sure that all the green LEDs flash when the product is switched on; this means the Communicator
is in its initialization phase.
14. Checking Signal Strength:
o
Make sure that at least one of the green LEDs remains lit; all green LEDs lit indicates optimal
coverage;
o
If the green LEDs are not illuminated, the signal strength is TOO WEAK; for the signal to be of an
acceptable level, at least one green LED must be lit.
15. Close the communicator: fasten the lower side of the cover [18] to the base [17] then press the upper edge
of the base to close the cover; fix the cover in place using screws [25].
CAUTION! Connect power circuit and the telephone line only after the cabinet has been secured to the
building or structure and has been connected to the protective earth ground of the building.
CAUTION! Before inserting or removing the SIM card, please ensure the unit is powered down.
ANT-EU Remote Antenna
For details of how to fit the remote ANT-EU outdoor antenna, please refer to the instructions supplied with
the product. The ANT-EU is used to provide the Communicator with excellent GSM signal strength.
D-305708 VGSM-120 Installation Instructions
7
Publicité
Table des Matières
