Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8. PROGRAMMING VIA PC
Note:
For proper function of this Communicator, use a 32 K SIM CARD (or higher).
For programming, the PC-Link cable (not supplied) must be connected to the Connector [9] of the Communicator
and a COM port on the PC (see Fig. 4); the VGSM-120 Console application is also required. The PC-Link
cable shown in Figure 4a, or the PC-Link cable shown in Figure 4b, can be used for the connection. Make sure
you insert the PC-Link cable connector in the right way. Once the PC-Link cable has been connected, set the
computer COM port through the the Options->Serial ports. Check the serial link and the serial port settings in
case of communication problem, or use a different USB-RS232 adapter.
Note:
To install and run the VGSM-120 Console application, you will need to log on to the PC as the
Administrator; we also recommend to verify the firewall's options if problems arise while the
application is being installed.
Viewing the Device Settings
To view the Communicator settings on the screen, use the Upload from board icon.
Downloading the Device Settings
Once programming has been completed (or an uploaded file containing existing data has been modified),
download the data into the Device, using the Download to board icon.
Preliminary operations
When the application starts, you will be presented with the Main window: if you use the mouse to click the menu
option Untitled #1 in the top left-hand part, two sections appear.
The following sections may be found within the general parameters section:
Customer information: this section can be used to recall and update the configuration corresponding
to a particular client as follows:
1.
Left-click on the application.
2.
Enter or update the information relating to the customer and the system. Click
Upload from board: If this icon is selected, the data programmed on the board is loaded onto the PC.
Download to board: If this icon is selected, the programmed data is sent to the board. Sending all of
the device settings or some "GPRS", "I/O" and "Optons" pages to the device will reset the Alarm
Communicator.
Factory defaults: Select this icon to restore the default settings. It should be noted that restoring the
default settings does not delete any voice messages recorded.
Board reset: If this icon is selected, the Communicator is reset.
18
D-305708 VGSM-120 Installation Instructions
to confirm.
Publicité
Table des Matières
