Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7. REMOTE PROGRAMMING BY SMS MESSAGE
In addition to the processes described in the section Remote activation and deactivation of the outputs, it is
also possible to carry out other remote procedures through the transmission of various SMS messages.
Changing the user code
The default user code is '0001'; to change it, send an SMS message consisting of the characters "#CUC"
followed by the old User code and the new User code between * characters, in accordance with the following formula:
You will receive an SMS confirmation if the User Code has been changed.
Note:
The User code may only consist of numbers from 0 to 9 (maximum 4 digits).
Enabling or disabling remote programming
Remote programming makes it possible to use the functionalities of the VGSM-120 Console software via a
network. In order to remotely manage the parameters of the Alarm Communicator, remote programming must
be enabled. This can be done using the VGSM-120 Console software (see the Programming via PC->GPRS-
>Remote Programming section), or by sending an SMS message consisting of the characters "#UWS" followed
by the User code and "ON" between * characters, in accordance with the following formula:
To disable the Remote Programming, send the following SMS message:
A text message will confirm whether the command was successful.
Changing the Installer code
The Installer Code (maximum 4 digits) is used for accessing the remote programming interface (see the
Programming via PC->Codes->Installer Code section). The default installer code is '0002'; to change it, send
an SMS message consisting of the characters "#CIC"followed by the old Installer code and the new Installer
code between * characters, in accordance with the following formula:
You will receive an SMS confirmation if the Installer Code has been changed.
Note:
The Installer code may only consist of numbers from 0 to 9 (maximum 4 digits).
Credit balance check
To find out the credit balance via SMS, you can either use the VGSM-120 Console software (see section
Programming via PC->Options->Pay As You Go), or you can find out remotely by sending an SMS message
consisting of the characters "#CCC" followed by the * character, in accordance with the following formula:
Note:
The balance SMS will be sent to the Telephone Number #1 of the Phonebook.
The pre-paid SIM CARD credit management service may be suspended at any time, at the
discretion of each individual GSM network operator.
D-305708 VGSM-120 Installation Instructions
#CUC*User code*New User code*
#UWS*User code*ON*
#UWS*User code*OFF*
#CIC*Installer code*New installer code*
#CCC*
17
Publicité
Table des Matières
