Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SMS
Send an SMS consisting of the User code between the # characters, the Control string (Control String
cannot have initial blank spaces) and the characters "=ON#","=ON#TonU#" or "=OFF#",as follows:
The "=ON#tonU#" option is parameter allows to set the ON Time from 1 to 86400 seconds, with 1
second steps. The ON Time can be set by means of the Communicator's Console software. "Ton" is the
required value and "U" is the unit in hours (H), minutes (M) and seconds (S), as shown in the following
example:
#9876#HOUSELIGHT=ON#
#9876#HOUSELIGHT=ON#3600
#9876#HOUSELIGHT=ON#50M# Active for 50 minutes
#9876#HOUSELIGHT=ON#3600# Active as per software programming,
Note:
Remove the "TonU" parameter, leaving the "##" characters, to activate the output by SMS as
programmed.
Caller Identification
Through caller identification: in this case the output is activated at "cost-free" as the Communicator, after
identifying the caller, rejects the call and activates the output.
Note:
Monostable OC outputs deactivate (switch OFF) automatically when the programmed ON Time
expires.
The ON time may be set to a period of time between 1 and 86400 seconds, in steps of 1 second.
Note:
The default User code is '0001'; if you wish to change it, please refer to the section "Remote
programming by SMS message->Changing the User code".
16
#User code#String=ON#
#User code#String=ON#TonU#
#User code#String=OFF#
SMS
Bistable Activation
Active for 3600 seconds
the set ON time does not apply
(example: #9876#HOUSELIGHT=ON##)
Output operating mode
D-305708 VGSM-120 Installation Instructions
Publicité
Table des Matières
