Visonic VGSM-120 Mode D'emploi page 25


Reserved Output: When this option is selected, all other events selected to activate the
corresponding output are ignored. Click the box corresponding to the output to be activated through
caller recognition or via an SMS command. To activate the output using caller identification, program
the telephone number on the "Phonebook" screen and enable the option "Activates output" (see
page Phonebook->Activates output).

Service: A tick  in this column indicates that the Communicator is in its SERVICE status, i.e. when
lines 1 and 2 become unbalanced, instead of making a call, the Communicator will take a specific action
independently. An action may be specified for each line, in accordance with the table below. In any case, if
these actions are selected, SMS messages are never sent in reference to inputs 1 and 2.
Input line Selection
no.
1
A
2 B
CAUTION! These settings also automatically update the parameters on the "SMS dialer", "Voice dialer"
and "Phonebook" pages.

Control String: In this column, enter the string (maximum 16 alphanumeric characters) to be sent by SMS
when you wish to activate/deactivate the corresponding remote output. This feature will operate even if caller
identification is not enabled.

Activation Confirmation: Use this column to select the type of confirmation you want when the
output is activated. There are 3 different options to choose from: None, Ring or SMS (the latter
option is not available if the Control string box has been left empty). The output activation confirmation
is forwarded by means of a SMS when the output is activated by SMS.

Monostable: Normally the outputs, when activated, remain so until a deactivation command is received,
at which point the output will revert to its standby status. If you want the output to revert to its standby status
automatically after a set amount of time, select this option and set the activation time using the adjacent
Monostable Time (sec) box.

Monostable Time (sec): In this box, enter the value in seconds (from 1 to 86400 in steps of 1
second) indicating the time period for which the output, if set as Monostable, will remain active
before reverting to its standby status (ON Time).
D-305708 VGSM-120 Installation Instructions
Forced switching on GSM network
Delete telephone queue
Table: Programming Effects on Activation Output
PROGRAMMING
Black List White List Activation
Confirmation
 
None
   
Ring
   
None
   
Ring
   
None
 
Ring
   
None
   
Ring
Enabled

Disabled

Associated Service function
EFFECTS
Call Forwarded
(only if the Communicator is
switched to the GSM network)
YES
NO
YES
NO
NO
NO
YES
NO
Confirmation
Ring
NO
YES
NO
YES
NO
YES
NO
YES
25