Local Service Mode; Sms Dialer; Periodic Sms - Visonic VGSM-120 Mode D'emploi

Local Service Mode

By selecting the Local service mode button, you can enable the voice messages playing/recording by a
touchtone telephone connected to the [LI] terminals of the device (refer to "Local Voice Message Recording" and
"Local Voice Message Replaying"). When this mode is enabled, the green LEDs L1 and L2 flash (see Status Leds-
>table 2). The LEDs only stop flashing when the recording or replaying procedure is complete, or after 60
seconds have elapsed without any of the buttons being pressed.
Note: You can connect ONLY ONE telephone to the [LI] terminals for proper working of the Local
Service Mode.

SMS dialer

This page is to setup the SMS dialer options, as indicated following.

Event type: The 'Event type' column has 11 separate lines listing the events for which two SMS messages
are sent, if programmed: one for activation and one for resetting (the "Periodic SMS" event only sends an
activation SMS).
Note: To select SMS messages for the 3 programmable input lines, set the corresponding terminal as
an input (see I/O->Type).

Telephone numbers: Click the '12345678' columns in accordance with the desired input. A tick 
indicates that the SMS message will be sent to a particular telephone number when the corresponding
event occurs.
Note: The telephone numbers are the first 8 entries on the "Phonebook" page.

SMS String: In the 'SMS String' column, click the box corresponding to the message to be programmed
and enter the message you wish to send when the relevant event occurs (maximum 100 characters).

Periodic SMS

This section is used to program periodic SMS message options.
Note: You MUST enter the "SIM Phone Number" and enable the "Auto Clock Adjusting" in the
"Options" page to setup the Periodic SMS's options.

Date of First Send: Select the date on which the first periodic SMS message is to be sent.

Time of First Send: Select the time at which the first periodic SMS message is to be sent.

Interval: Enter the interval (HH-DD) at which subsequent periodic SMS messages are to be sent. The
interval consists of the following values:
(HH) next message time - Select the time at which you wish to send the next periodic SMS. The
o
interval for these values may be set between 0 and 23.
(DD) next message day - Select the day on which you wish to send the next periodic SMS. The
o
interval for these values may be set between 0 and 365.

Update time: Select this icon to get local date and time from the PC.
D-305708 VGSM-120 Installation Instructions 27