Operating Instructions; Operating Control Panel - Napoleon Allure Vertical Serie Manuel D'installation

5.0 operating instructions

EN
WARNING
!
• Ensure the house circuit breakers for the power supply are turned on. When initially connecting the appliance to
a power source, the appliance will perform an LED check. The appliance will flash on and off for 5 seconds.
Once the appliance has been plugged into a grounded electrical outlet or hard wired to a dedicated 120V power
supply, it is ready to operate.
5.1

operating control panel

The Control Panel is located on the right side of the appliance (when viewed from the front).
Power
Ember Bed Light
Flame Control
F° / C° Switch
Heater Control
Heater Lock
20
W415-1830 / G / 07.20.20
Turns the appliance on/off.
Controls ember bed light settings.
Settings:
L0 - Ember bed light off
L1 - White
L2 - Blue
L3 - Green
L4 - Red
L5 - Yellow
L6 - Purple
L7 - Auto-cycle through white, blue, green, red,
yellow, and purple. (NOTE: It will take 8.5 seconds
to switch between colours.)
L8 - Lock to desired color
Controls flame.
8 Settings:
00 - Flame off
01 - Orange flame
02 - Yellow flame
03 - Blue flame
04 - Yellow / orange flame
05 - Orange / blue flame
06 - Yellow / blue flame
07 - Yellow / orange / blue flame
Changes temperature format from Fahrenheit to Cel-
cius or vice versa. Press and hold the Flame button
for 5 seconds.
Turns the heater and blower on/off.
4 Settings:
H0 - Heater and blower off
bL - Blower on
H1 - Low heat
H2 - High heat
Heater button can be locked or unlocked by holding
the Heater button for 5 seconds.