Finishing; Crystal Ember Installation; Birch Wood Log Installation (Nefvc38H Only) - Napoleon Allure Vertical Serie Manuel D'installation

WARNING
!
• Power supply service must be completed prior to finishing in order to avoid reconstruction.
• Heat vents and air openings cannot be covered under any circumstances.
3.1

crystal ember installation

note:
The door glass must be removed and the appliance must be secured in its final location before the crystal
embers are installed (see "door glass removal" section).
1. Carefully place the small crystal embers into the bottom media tray (Fig. 1).
2. Apply an even layer from side to side.
3. Randomly place the 3 large crystal embers on top of the small crystal
embers.
3.2

birch wood log installation (NEFVC38H only)

note:
Birch wood logs are included with NEFVC38H models only.
note:
The door glass must be removed and the appliance must be secured in its final location before the birch wood
logs are installed into NEFVC38H models only (see "door glass removal" section).
1. Carefully place birch wood logs on the media tray (see below illustration for recommended placement).
2. Use the small crystal embers (see "crystal ember installation" section) to fill in spaces between the birch wood
logs. This will improve the overall look of the appliance.
Reference Log Number
A W135-0768
B W135-0770
C W135-0769
C
Recommended birch wood log placement (NEFVC38H only)

3.0 finishing

Fig. 1
B
A
W415-1830 / G / 07.20.20
EN
15