Door Panel Installation - Bosch SHI Instructions D'installation

25"
(636 mm)
23-1/16"
(586 mm)
Figure 15
Figure 16
Figure 17

Door Panel Installation

DOOR PANEL INSTALLATION
SHU Models - Accessory Panel Installation
If you have an SHU model and have ordered an accessory
panel kit, install the panel prior to sliding the dishwasher
1/4" max.
(6 mm)
into place. The panel dimensions are shown in Figure 15.
SHI Models - Panel Installation
SHI models come with additional mounting hardware and a
template sheet with installation instructions. The stainless
steel models of the SHI series also come with two exten-
sion pieces. The extension pieces are used to match the
control panel height (Figure 16, "B" dimension) to the
horizontal drawer line of the cabinets, and must be
installed as shown in on the template sheet. The standard
piece is used for drawer heights up to 6" (152mm); the long
piece is used for drawer heights greater than 6" (152mm)
but 6-7/16" (164mm) or less. If your drawers are taller than
6-7/16", you can either slide the extension piece in as far
as it will go, or remove it and fit the door panel directly
below the control panel.
SHI/SHV Models - Panel Installation
SHV models come with additional mounting hardware and
a template sheet that will show you how to mount the
panel. One side of the template shows how to mount a one
piece panel; the other side shows how to mount a two
piece panel. Decide which type of installation you want
before proceeding with the installation.
Fig. 16
Dimension
SHI Only
Extension "A"
Max. - Min.
Standard Long
5 5/16
1 1/8 - 11/16"
11/16 - 5/16"
(135mm)
(18-8mm) (29 - 18mm)
Fig. 17
Panel Dimension
Dimension
20 11/16" - 25"
D (SHI)
(526mm - 635mm)
E
27 3/16" - 30 5/16"
(SHI & SHV)
(690mm - 770mm)
F
23 3/16" - 23 3/8"
(SHI & SHV)
(589mm - 594mm)
"C"
"B"
Max.-Min.
6 7/16 - 5 5/8
(164 - 143mm)
9