Final Instructions - Bosch SHI Instructions D'installation

Base and Toe Panel/ Final Instructions
BASE AND TOE PANEL (Continued)
SHY66 & SHX99A Models Base and Toe Panel Installa-
tion
1) Place the Base Part under and up the front bottom panel
of the dishwasher, as shown in Figure 31.
A
2) Insert the Base Part screws (Figure 1, letter O) into the
C
Base Part, as shown in Figure 31, letter B. Tighten the
Base Part Screws.
3) Place the Cotton Insulation Strip (Figure 1, letter C)
B
under the unit, between the bottom of the Base Part and
the floor, as shown in Figure 31, letter C.
D
4) Place the toe panel over the Cotton Insulation Strip, and
use the toe panel screws (Figure 1, letter N) to secure the
toe panel in place, as shown in Figure 31, letter D.
Figure 31

FINAL INSTRUCTIONS

1) Energize the dishwasher power supply circuit.
2) Consult the Dishwasher Use and Care Manual, and run
the dishwasher through one complete cycle.
If the dishwasher does not operate properly, refer to the
Self-Help section of the Use and Care Manual. If the
dishwasher still does not operate properly, refer to the
Customer Service Section of the Use and Care Manual.
15