Installing Your Hob In Complete Safety - Brandt TI200 Guide D'utilisation Et D'installation

9962 5741.qxd 09/09/02

Installing your hob in complete safety

Above a cupboard or drawer unit
Ensure that the unit crossbar does not block the air
passage, make a bevel if necessary.
mini 40 cm2
When several heating zones are used
simultaneously over long periods of time, or in
hot climatic conditions, we recommend that
openings be made in the side of the unit near
the air escape to allow the hot air to be
evacuated more easily.
Your induction hob must always be adequately ventilated.
Make sure that the air inlet through the fan grid at the back is not obstructed.
If these recommendations are not adhered to, the hob may overheat, switch into the "safety" position
and stop temporarily (F7 or a series of small lines can be seen on the display)
The hob must not be fitted above a washing machine, a refrigerator or a deep-freeze.
10:34 Page 6
Above an oven of the same
make
Oven in the HIGH or LOW position
mini 40 cm2
For example 8 x 5cm
Above an oven of a different make
6
Oven in the LOW position
mini 5 cm
mini 4 mm
Kit d'isolation (SAV)
Compulsory
isolation kit available
from the after-sales
service 75X1652
mini 4 mm