Scott Proflow2 SC 120 Instructions D'utilisation page 17

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 45
4. Battery
General
o
Charge the battery before use. The recharging time of an empty battery is about 7 hours. The
temperature of the battery to be recharged must be +10 C...+ 30 C.
Recharging should always take place at a room temperature of about +20 C, in a dry place shielded
o
from dust and direct sunlight.
Always use the Proflow's own recharging device (it is delivered with the blower unit). The recharger
o
performs a battery test at start of each charging to detect defective batteries.
o
Optimum performance with new battery packs is achieved only after they have completed three
charge-cycles.
Note!
o
A new battery or a battery stored for a longer period or an over-discharged battery may not function
stably, which will terminate the recharging prematurely. Monitor the red signal light (=charging in
operation) after e.g. 30 or 60 minutes and initiate the recharging several times if needed.
o
In too cold/warm an environment the battery will not be charged.
o
Never recharge in a potentially explosive environment!
o
When not in use, prevent over-discharge of battery by keeping the blower device always on
recharge. Overcharging of battery is automatically prevented.
Recharging
Connect the recharging device to the main power supply (100-240 V/ 50 Hz). When not connected to
the blower device, the signal light will not start burning.
Open the protective lid of the blower's charging connector.
Push the recharging plug into the charging connector and turn the plug slightly clockwise until it sits
fast, otherwise the battery will not be charged. The charging will start automatically.
Throughout the recharging, the recharger's red signal light remains on. The time needed depends on
o
the battery status.
o
Recharging is complete when the red signal light goes out, and the green signal light starts burning
and stays on (standby level).
o
The recharging plug will come off when you pull the locking and simultaneously turn the plug counter-
clockwise. Then close the protective lid.
Signal lights on the recharging device
Red light on:
Green light on:
Red light blinking::
2
1
= Charging in operation.
= Battery fully charged (standby charge).
= Wrong or defective battery.
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Proflow2 sc 160Proflow3 120Proflow3 180

Table des Matières