Greasing The Sealing Ring Of The Pump - FLORABEST 271130 Mode D'emploi

9934543-Drucksprue_man 19.10.15 14:17 Seite 11
• After cleaning, insert the pipe back
into the intended opening of the tank.
• Turn the cap nut until hand-tight.
• Cleaning the valve
• If required, remove the screw cap (10)
of the valve spring, remove the
spring, clean and replace. Tighten the
screw cap hand-tight.
• Storing the pressure spraying
device
• Before you store the pressure
spraying device, clean it.
• Remove any residual fluids/spray
from the tank and the pipes.
• Allow all parts to dry well
• Store the pressure spraying device at
0°C – 40°C in a dry, dust-free
location.
• Protect the pressure spraying device
from frost and store away from frost.
Troubleshooting
If the measures listed below are not
successful, contact the manufacturer.
© = Fault
= Potential causes
k = Remedies
© No pressure is established in the
tank.
The pump is not firmly screwed into
place.
k Screw the pump firmly into place.
The sealing ring of the pump has not
been greased.
k Grease the sealing ring of the pump.
© Spray nozzle does not spray.
No pressure present.
k Generate pressure using the pump.
The spray nozzle is blocked.
k Clean the spray nozzle.
No spray in the tank.
k Fill with spray.
Filter (12) is blocked.
k Clean the filter.
Disposal
Inquire in your town or
community administration
about recycling options or
the environmentally friendly,
correct disposal of the
pressure sprayer device.
Dispose of the device and
any packaging materials in
accordance with the locally
applicable regulations.
11