Electrical Safety - Black & Decker SVJ520BFS Mode D'emploi

ENGLISH
Even with the application of the relevant
safety regulations and the implementa-
tion of safety devices, certain residual
risks can not be avoided. These include:
Injuries caused by touching any
u
rotating/moving parts.
Injuries caused when changing any
u
parts, blades or accessories.
Injuries caused by prolonged use
u
of a tool. When using any tool for
prolonged periods ensure you take
regular breaks.
Impairment of hearing.
u
Health hazards caused by breathing
u
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your BLACK+DECKER charger
u
only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/battery must be
u
placed in a well ventilated area when
charging.
8
(Original instructions)

Electrical safety

Symbols on the charger
Read all of this manual carefully before using the
#
appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
w
corresponds to the voltage on the rating plate.
Short circuit proof safety isolating transformer. The
mains supply is electrically separated from the
x
transformer output.
The charger automatically shuts off if the ambient
temperature becomes too high. As a consequence
the charger will be inoperable. The charging base
must be disconnected from the mains supply and
$
taken to an authorised service centre for repair.
The charging base is intended for indoor use only.
Labels on appliance
+
The following symbols appear on this appliance along with the
date code
Read all of this manual carefully before
using the appliance
Only use with charger S010Q 23
S010Q 23
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Nozzle
3. Pull out crevice tool
4. Push in brush
5. Handle On/off power switch
5A. Brush control
6. Handle
7. Charging base
8. Chassis
8a. Chassis release button
Use
Switching on and off (Fig. A)
To switch on, press the on/off switch (1) located on the
u
handle of the Dustbuster
handle (5).
Press the button again (1 or 5), and the unit goes to a
u
BOOST mode.
To switch off, press the on/off switch (1) or (5).
u
, or alternatively on the chassis
®