Installing Natural Gas; Converting From Natural Gas To Propane - NewAge Products 65900 Manuel D'installation Et Fonctionnement

Installing Natural Gas in NewAge Cabinet
1
Grill is pre installed for Natural Gas and includes
a pre assembled hose.
** Grease tray removed for ease of explaination.
3
* The outdoor cooking gas appliance
shall not be used under overhead
combusible construction
Side - 10" Clearance
Rear - 18" Clearance
18 Inches
10 Inches
WARNING!
• Never install this product into a combustible enclosure without an
insulated jacket. Doing so could result in fire, property damage
!
and personal injury.
• Never locate the grill under a roof or overhang, in a building, garage,
shed or other such enclosed area.
• Never locate the grill under unprotected combustible construction.
• Installation must conform with local codes or, in the absence of local
codes, with either the National Fuel Gas Code, ANS Z223.1/NFPA 54,
Natural Gas and propane Installation Code, CSA B149.1, or Propane
Storage and Handling Code, B149.2, in Canada.
10
www.newageproducts.com
2
Connect to Natural Gas supply using the
quick connect fitting.
Pull back collar on
connector
3
WARNING! The grill and cabinet must have a
minimum clearance from combustible materials.
Refer to below figure for dimensions.

Converting from Natural Gas to Propane

Remove the grill grates, ceramic briquette
1
trays, and rotisserie.
3
It is important to understand that wherever there is
a burner (B), there is a propane orifice that will need
3
to be added (do not forget the sear burner or the
rotisserie). The back access panel must be removed
to replace injector oriface for rotisserie.
B
To access the injector orifaces for the burners,
5
there are holes located on the front inside of
the fire wall.
www.newageproducts.com
Unscrew the bolt (A) at the end of each burner,
2
and tilt and lift out from the grill.
This process is as simple as screwing in the
propane orifaces (included with purchase) into
4
the existing valve end.
B
Begin by applying pipe dope to the propane
oriface threads. Hand thread the propane orifice
6
in and using a 6 mm nut driver tighten the
injector nut.
A
11