Saber R50SB1517 Manuel D'utilisation Et D'entretien page 12

INSTALLATION CON'T.
3. Electrical Transformer:
(Transformer mounting fasteners not provided)
NOTE: A licensed electrician should be used to install the transformer and make any wiring extensions.
A licensed electrician should use fasteners appropriate for the type of materials used to build the enclosure.
This grill has been supplied with enough wire to mount the lighting electrical transformer in the location shown (see Figure 4). The
lighting electrical transformer can be mounted in a different location by extending the transformer wires on the low voltage output
side of the transformer (see Figure 4). Wire extensions are not provided and should be made of materials with equivalent ratings to
the low voltage output wires (see rating printed on each wire). If extending the wires, take care to maintain the factory-provided
connections that connect the wires to the other grill components. The transformer must be properly grounded using the grounding
wire attached to the transformer. A properly grounded GFI outlet should be installed in proximity to the transformer such that the
grounded plug on the high voltage input wires provided easily connects to the GFI outlet. DO NOT ATTEMPT to extend the high
voltage input wires.
FAILURE TO PROPERLY GROUND TRANSFORMER COULD RESULT IN ELECTRICAL SHOCK.
DO NOT ATTEMPT TO EXTEND THE HIGH VOLTAGE INPUT WIRES.
8.25"
12
WARNING
Low Voltage
Output Wires
Electrical
Transformer
High Voltage
Input Wires
5.88"
Figure 4
An additional connector is
provided to supply power to the
LED lights on the SABER
K00SB5317 Built-in Side Burner
(sold separately). Reference the
assembly instructions with the side
burner for additional information.