Closing The Door; Replacing The Lamp - Electrolux EN3453OOX Notice D'utilisation

32 www.electrolux.com
Problem
Water flows on the floor.
Temperature cannot be set. The FastFreeze or Shop-
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.

8.2 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Possible cause
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
pingMode function is
switched on.
The appliance is not level-
led.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The FastFreeze function is
switched on.
There is no cold air circu-
lation in the appliance.

8.3 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Solution
Attach the melting water out-
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FastFreeze
or ShoppingMode function".
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
Refer to "FastFreeze func-
tion".
Make sure that there is cold
air circulation in the appli-
ance.