Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
14 www.electrolux.com
Problem
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.
There is too much
frost.
6.1 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter .
6.2 Closing the door
1.
Clean the door gaskets.
7. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
All manuals and user guides at all-guides.com
Possible cause
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed
correctly.
Solution
Make sure that products do
not touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Refer to "Closing the door".
2.
If necessary, adjust the door. Refer to
"Installation".
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Publicité
Chapitres
Table des Matières
