Stroller Operation
Adjust Recline
Recline Backrest
7
Pull tab to recline backrest.
!
Hold the backrest with the other hand if a child is already seated in the stroller.
Raise Backrest
Hold both left and right strings and push up the angle adjuster to raise backrest.
!
Make sure the backrest angle is set properly for use.
Use Bumper Bar
The bumper bar can be pulled up on both left and right sides.
9
- 1
Press bumper bar release button
, and then pull up the bumper bar
with matching component, and then push down to lock.
Tip
Bumper bar can be open for easily placing and removing.
Use Buckle
Release Buckle
10
Press the center button to release the buckle.
Lock Buckle
Match the waist belt buckle with the shoulder buckle
A click sound means the buckle is locked completely.
!
To avoid serious injury from falling or sliding out, always secure your child with harness.
!
Make sure your child is snugly secured. The space between the child and the shoulder harness is about the
thickness of one hand.
!
Do not cross the shoulder belts. This will cause pressure on child's neck.
Use Shoulder & Waist Harnesses
!
In order to protect your child from falling out, after your child is placed into the seat, check whether the
shoulder and waist harnesses are at proper height and length.
12
- 1
Shoulder harness anchor A
12
- 2
Shoulder harness anchor B
12
- 3
Slide adjuster
For larger child, use shoulder harness anchor A and the highest shoulder slots. For smaller child, use shoulder
harness anchor B and the lowest shoulder slots.
To adjust the position of the shoulder harness anchor, turn the anchor to be level with the short side facing
forward. Thread it through the shoulder harness slot from back to front
13
- 2
is closest to child's shoulder height.
Use slide adjuster to change the harness length.
14
- 2
Press the button
, while pulling the waist harness to proper length
11
8
9
- 2
. Align the bumper bar end
11
- 1
11
- 2
, and click into the center buckle.
11
- 3
13
- 1
. Rethread it through the slot that
14
14
- 3
.
Adjust Calf Support
15
There are two recline angles, 1-2
for adjustment.
To raise calf support, push the calf support from position 1 to position 2
To lower calf support, pull the calf support outward
16
- 2
to position 1.
Use Hood
To open the hood, pull canopy toward front and press stretchers down on both sides.
To fold the hood, pull up the stretchers on both sides
Use Front Swivel Lock
Pull up the front swivel locks to maintain the moving direction.
Tip
It is recommended to use swivel locks on uneven surfaces.
Use Brake
19
To lock wheels, step on the brake lever as
. The stroller wheels are locked on the condition that the brake is
stepped on.
Lift the brake lever to release wheel.
Tip
Always apply brake when stroller is in stopped position.
Fold Stroller
17
- 1
Before folding, pull up canopy stretchers.
20
- 1
Push secondary lock
and squeeze one-hand-fold handle
21
sound means the stroller is folded completely.
Accessories
Accessories may be sold separately or may not be available depending on region.
Use Rain Cover
To assemble the rain cover, place it over the stroller, and then attach the 2 pairs of hook and loop fasteners and
22 23
4 pairs of snaps on the rain cover.
!
Before using the rain cover, please make sure the backrest has been adjusted to the lowest position and the
infant car seat has been fastened.
!
When using the rain cover, please always check its ventilation.
!
When not in use, please check that the rain cover has been cleaned and dried before folding.
!
Do not fold the stroller after assembling the rain cover.
!
Do not place your child into the stroller assembled with rain cover during hot weather.
!
When using your stroller at the beach, completely clean your stroller after use to remove sand and salt from
mechanisms and wheel assemblies.
15
.
16
- 1
, meanwhile recline the calf support from position 2
17
17
- 1
and pull canopy toward back.
18
20
- 2
. Push the stroller forward to fold. A click
12