Stroller Operation; Adjust Recline; Adjust Calf Support - Joie extoura Manuel D'utilisateur

3. Place the rear wheel and washer on one side of the rear axle.
4. To secure the wheel and the washer to the axle, push the straight side of the pin through the hole on
10
the axle.
11
The assembled pin is shown as.
!
The curve side on the pin must curve around the outside of the axle.
!
Make sure the washer is between the pin and the wheel.
5. Line up the tabs on the cap with the holes on the wheel, snap the cap onto the wheel to cover the
12
washer and pin.
The completely assembled rear wheels are shown as.
Assemble Tray
Align the tray end with matching component, and then push down to assemble the tray.
15
The completely assembled stroller is shown as.

Stroller Operation

Adjust Recline

There are 5 angles for the backrest.
To recline the backrest, squeeze the recline handle on the back of the seat and
16 - 2
backrest.
To raise the backrest, push up.
!
Make sure the recline is set properly for use.

Adjust Calf Support

17
There are 3 recline angles, 1-3 for adjustment.
To raise calf support, push the calf support from lower position to higher position.
To lower calf support, pull the calf support outward
- 2
18
position to lower position.
Use Tray
The tray can be pulled up on both left and right sides.
19 - 1
Press tray release button , and then pull up the tray.
Tip
Tray can be open for easily placing and removing.
13
9
13
14
16 - 1
pull down on the
17
18 - 1
, meanwhile recline the calf support from higher
19 - 2
Use Buckle
Release Buckle
20
Press the center button to release the buckle.
Lock Buckle
Match the waist belt buckle with the shoulder buckle
A "click" sound means the buckle is locked completely.
!
To avoid serious injury from falling or sliding out, always secure your child with harness.
!
Make sure your child is snugly secured. The space between the child and the shoulder harness is about the
thickness of one hand.
!
Do not cross the shoulder belts. This will cause pressure on child's neck.
Use Shoulder & Waist Harnesses
!
In order to protect your child from falling out, after your child is placed into the seat, check whether the
shoulder and waist harnesses are at proper height and length.
22 - 1
Shoulder harness anchor A
22 - 2
Shoulder harness anchor B
22 - 3
Slide adjuster
For larger child, use shoulder harness anchor A and the highest shoulder slots. For smaller child, use shoulder
harness anchor B and the lowest shoulder slots.
Use either shoulder harness anchor in the slots that are closest to child's shoulder height.
Use slide adjuster to change the harness length.
24 - 2
Press the button , while pulling the waist harness to proper length.
Use Hood
Use Hood Window
The hood window makes it more convenient to view child.
There is one window on the hood.
25
To open the window, flip the fabric flap forward.
Open Hood
To open the hood pull hood towards front and press stretchers down on both sides.
Fold Hood
To fold the hood, pull up the stretchers on both sides
Remove Hood
27 - 1
To remove hood, press the snap finger , and pull out hood pivot.
21 - 1 21 - 2
, and click into the center buckle.
21 - 3
23
24
- 1
24 - 3
26
26 - 1
and pull hood toward back.
27 - 2
14