Atag VA63211RF Mode D'emploi page 13

A B D
30
20
1. Press the release button (B) to open the
lid (C).
2. Put the detergent, in powder or tablets,
in the compartment (A).
3. If the programme has a prewash phase,
put a small quantity of detergent in the
compartment (D).
4. Close the lid. Make sure that the release
button locks into position.
Setting and starting a
programme
The AUTO OFF function
This function decreases energy
consumption by deactivating automatically
the appliance when it is not operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.
Starting a programme
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in programme selection mode.
2. Close the appliance door.
3. Press Program again and again until
the indicator of the programme you
want to select comes on.
The display shows the programme
duration.
4. Set the applicable options.
5. Press Start to start the programme.
C
• The washing phase indicator comes
on .
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with
delay start
1. Set a programme.
2. Press Delay again and again until the
display shows the delay time you want
to set (from 1 to 24 hours).
The indicator of the selected programme
flashes.
3. Press Start.
4. Close the appliance door to start the
countdown.
When the countdown is completed, the
programme starts and the washing phase
indicator comes on.
Opening the door while the
appliance operates
If you open the door while a programme is
running, the appliance stops. When you
close the door, the appliance continues
from the point of interruption.
If the door is opened for more
than 30 seconds during the
drying phase, the running
programme will end.
Cancelling the delay start while
the countdown operates
When you cancel the delay start you have
to set the programme and options again.
Press and hold simultaneously Program
and Option until the appliance is in
programme selection mode.
Cancelling the programme
Press and hold simultaneously Program
and Option until the appliance is in
programme selection mode.
13