Using The Cooler - Dometic CFF35 Notice D'utilisation

Operation
➤ Press the "SET" button (fig. 3 5, page 4) three times.
➤ Use the "UP +" (fig. 3 7, page 4) or "DOWN –" (fig. 3 6, page 4) buttons to
select the battery monitor mode.
✓ Display will be as follows:
Lo (LOW), ΠEd (MED), Hi (HIGH)
✓ The selected mode then appears in the display for a few seconds. The display
flashes several times before it returns to the current temperature.
I
NOTE
When the cooler is supplied by the starter battery, select the battery
monitor mode "HIGH". If the cooler is connected to a supply battery,
the battery monitor mode "LOW" will suffice.
6.5

Using the cooler

A
NOTICE!
OVERHEATING HAZARD!
Failure to obey this instruction may result in damage to the device.
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate. We recommend keeping a gap of at least 2" around ventilation holes.
I
NOTE
Place the cooler as shown (fig. 1, page 3). If you operate the cooler in
a different orientation it can be damaged.
➤ Connect the cooler, see chapter "Connecting the cooler" on page 16.
A
NOTICE!
EXCESSIVELY LOW TEMPERATURE HAZARD!
Failure to obey this instruction may result in damage to the objects
placed in the cooler.
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
18
CFF35, CFF45
EN