Remote Thermostat Mode - Rinnai EX17CT Manuel D'installation Et D'utilisation

Remote Thermostat Mode (Optional Accessory)
A remote thermostat can be installed for the furnace with the Remote Thermostat Installation Kit (Part # 204000045).
Once installed, the furnace must be placed in Remote Thermostat mode by following the steps below:
1. Ensure the furnace is plugged in but is turned OFF.
2. Ensure the Set back feature is turned OFF.
3. Press and hold the Economy + Up + Program buttons for 2.5 seconds and then release (00 appears in the
display).
4. Press the UP button (01 appears in the display).
5. Press the ON/OFF button; the display will go blank. The furnace is now in Remote Thermostat mode.
ATTENTION
Note: To return the furnace back to Control Panel mode, repeat steps 1-3. At step 4, press the UP button until 02
appears in the display. Next, press the ON/OFF button; the display will go blank. The furnace is now in Control
Panel mode.
ECONOMY
ATTENTION
DO NOT place heater back into "00" default factory setting without wall thermostat connection components.
Failure to do so may cause the unit not to function properly.
The following buttons/indicators on the control panel will remain functional in either mode:

ON/OFF Button

FILTER Indicator

ON Indicator

DISPLAY (The DISPLAY will be blank except in the event of an error code. All error codes will show on the
DISPLAY in either mode. Error codes will not show on the remote thermostat even when in remote thermostat
mode.)
ATTENTION
26
Do not unplug the furnace within two hours of entering Remote Thermostat
mode. This will cause the furnace to revert back to Control Panel mode (default).
00 -
Default Factory Setting
01 -

Remote Thermostat Mode

02 -
Control Panel Mode
The remote thermostat will NOT control the heaters ability to power on or power down.
This must still be done by using the ON/OFF button of the heater.
Rinnai Corporation EX17CT, EX22CT Manual
UP SET TIMES