Maintenance And Environmental Protection - Meister FP80M Traduction Du Manuel D'utilisation Original

Spraying
Fill the tank with the correctly thinned
and sieved paint.
Connect the spray gun to the mains power
supply. Aim at a piece of scrap paper and
actuate switch (3) until paint emerges.
Set the control knob (2), so that the paint
quantity required is discharged. Turn the
knob clockwise to reduce the discharge
flow and counter clockwise to increase it.
The setting of the discharge flow will affect
the spray pattern. With a flawed spray
pattern, the paint is concentrated in the
centre of the jet spray, which will lead to
irregular paint distribution on the surface.
The jet spray is correctly set, if the paint is
uniformly distributed over the jet spray as
a whole.
Spraying techniques
To obtain best possible results, the spray
gun must always be held upright and
parallel to the surface. Keep a distance
of 20 to 30 cm between the spray nozzle
and surface, and spray uniformly back-
wards and forwards, up and down. Do
not spray at another angle to the surface,
because the paint will otherwise run
down. A gentle and uniform movement is
important. Spray large surfaces crosswise
(see Figs. 3, 4 and 5).
Never switch the spray gun on or off,
while it is aimed at the surface to be
sprayed. Always move the spray gun
at an unvarying rate. Rapid movement
results in a thin layer of paint, slow
movement in a thick layer. Only one
layer should be applied per spray pass.
Should another layer prove necessary,
the recommendations of the paint
manufacturer for drying times must
be maintained. When spraying small
surfaces, set the control knob (3) to
low. This will avoid too much paint
5412950-Farbspritzgeraet_man.indd 47 5412950-Farbspritzgeraet_man.indd 47
consumption and too thick application.
When spraying, avoid switching the
appliance on and off frequently, because
too much or too little paint might be
thus applied. Do not tilt the spray gun
lower than 45°.
Mounting and use of the nozzle
extension
The nozzle extension simplifies work at
inaccessible places such as between the
ribs of radiators. To mount the nozzle
extension, unscrew the spray nozzle and
screw on the extension instead. Now
screw the spray nozzle 0.5 mm (12) to
the end of the nozzle extension and
tighten (see Fig. 6).
9 – Maintenance and
environmental protection
Cleaning and maintenance
ATTENTION! Be sure to pull the
mains plug prior to cleaning the
spray gun or paint tank.
• During use, paint particles and dried
residual paint may block the spray
nozzle. This can be removed carefully
from the nozzle opening by using the
cleaning needle (11).
• Clean the spray gun thoroughly each
time after use. Omitting to do this will
lead almost inevitably to blockages
and consequently to malfunctions of
the appliance in subsequent use. The
guarantee does not include cleaning
of the spray gun, which has not been
thoroughly cleaned by the user.
ATTENTION! The following work
must be carried out each time
after use:
47
09.07.20 11:38 09.07.20 11:38