Handling Instructions/Preliminary Work - Meister FP80M Traduction Du Manuel D'utilisation Original

• Disconnect the appliance from
the mains prior to all repair and
maintenance work or before exchanging
individual parts.
• When using outside closed rooms,
use a mains cable extension designed
for this.
• Always work in a concentrated manner!
Use your common sense! Take a break
if you get tired of working.
• Repair work should only be done by
appropriately qualified specialists. When
exchanging individual parts, only
use original parts or those expressly
recommended by the manufacturers
in order to largely preclude any
potential danger.
• Do not spray highly inflammable
liquids with this appliance.
• Do not clean the appliance with
inflammable solutions.
DANGER! Risk of explosion
or catching fire with paints or
thinners! Injuries and serious damage
might ensue! Rule out where possible
any potential ignition sources, such
as sparks, naked flames, cigarette
lighters, cigarettes.
DANGER! When inhaled, paints
and thinners have a toxic effect!
Giddiness, fainting or other symptoms
of poisoning may ensue!
DANGER! Never pull the plug
from the power socket by the
cable! Danger of electric shock!
ATTENTION! In case of injury,
immediately consult a specialist
doctor.
5412950-Farbspritzgeraet_man.indd 45 5412950-Farbspritzgeraet_man.indd 45
Safety symbols
The symbols on the housing have the
following meanings:
Do not dispose of with
domestic waste!
Important! Observe operating
instructions!
Wear a dust protection
mask.
„Tested Safety" voluntary
quality mark
Housing is double insulated
CE Mark (conformity to
European safety standards)
BJ Year of construction
SN: Serial number
SN: XXXXX The first two underlined
numbers give the month of
manufacture.
7 – Handling instructions/
Preliminary work
ATTENTION! First of all, make a
test application!
After mixing the paint, check the atomised
spray from the spray gun on scrap paper to
get a feeling of how the spray gun works.
Always ensure that the distance to the
surface you are working on is about
30 cm.
1. Check to see whether the intake tube
has been firmly installed in the pump
45
09.07.20 11:38 09.07.20 11:38