Maintenance And Cleaning - Blomberg TAF 7239 Mode D'emploi

5

Maintenance and cleaning

Filter Cartridge / Door Inner Surface
Lint and fibres released from the laundry to the
air during the drying cycle are collected in the
"Filter Cartridge".
C
Such fibre and lint are generally formed
during wearing and washing.
C
Always clean the filter and the inner
surfaces of the cover after each drying
process.
C
You can clean the filter and filter area by
vacuum cleaner.
To clean the filter:
1. Open the loading door.
2. Remove the cover filter by pulling it up and
open the filter.
3. Clean lint, fibre, and cotton raveling by
hand or with a soft piece of cloth. 4.
Close the filter and place it back into its
seat.
C
Clogging may arise on the filter surface
after using your machine for some time; if
this occurs, wash the filter with water and
dry it before using again.
C
Clean the entire inner surface of the cover
and door gasket.
.Sensor (models equipped with a sensor)
There are humidity sensors in your machine
that detect whether the laundry is dry or not.
For sensor cleaning;
1. Open the door of the machine.
2. Allow the machine to cool off if drying has
been carried out.
3. Wipe the metal sensors with a soft cloth,
dampened with vinegar and dry them.
C
Clean metal sensors 4 times a year.
A
Never use solvents, cleaning agents or
substances alike when cleaning as these
might cause fire and explosion!
16 EN