Technical Characteristics; Diagnostics Led - tau K120M Notice D'installation

CONTROL BOARD FOR T-ONE3B GEARMOTOR
• MICROPROCESSOR-CONTROLLED LOGIC
• INPUT STATUS LED'S
• LINE INPUT FUSE
• "PEDESTRIAN GATE" FUNCTION
• BUILT-IN FLASHING LIGHT CIRCUIT
• 433.92 MHz 2 CHANNEL BUILT-IN RADIO RECEIVER (CH)
• BATTERY CONNECTOR
• ENCODER SENSOR FOR OBSTACLE DETECTION AND SELF-LEARNING OF TRAVEL
• ADJUSTABLE DECELERATION
• DIAGNOSTICS OF MALFUNCTIONS SIGNALLED BY LED
• EN COMPLIANT AND CERTIFIABLE UP TO 300 KG LEAF
ATTENTION:
- do not use single cables (with one single wire), ex. telephone cables, in order to avoid
breakdowns of the line and false contacts;
- do not re-use old pre-existing cables.
TESTING
When you have completed the connection:
• All the green LEDs must be on (each of them corresponds to a Normally Closed input). The go off
only when the controls to which they are associated are operated.
• All the red LS LEDs must be off (each of them corresponds to a Normally Open input). The light up
only when the controls to which they are associated are operated. Except for the DL3 diagnostics
led which must always be on.

TECHNICAL CHARACTERISTICS

Board power supply
Max motor power DC
Fast acting fuse for protection of input power supply 13.5 V AC (F1 - 5x20)
Fast acting fuse for motor protection (F2 - 5x20)
Fast acting fuse for protection of auxiliary circuits 24 V DC (F3 - 5x20)
Motor power supply circuits voltage
Auxiliary device circuits supply voltage
Logic circuits supply voltages
Operating temperature
Box protected to

DIAGNOSTICS LED

DL1 (PEDESTRIAN)
DL2 (OPEN/CLOSE)
DL3 (ERR)
DL4 (STOP)
DL5 (PHOTO)
DL6 (SENSITIVE EDGE)
DL7 (TENSION)
PEDESTRIAN button red LED signal
OPEN/CLOSE button red LED signal
ERRORS red LED signal
STOP button green LED signal
PHOTOCELL green LED signal
SENSITIVE EDGE green LED signal
POWER ON (also battery voltage) green
K120M
18,5 V AC - 50 Hz
50 W - 24 V DC
F 16 A
F 10 A
F 2 A
24 V DC
24 V DC
5 V DC
-20 °C ÷ +70 °C
IP 44
LED signal
15