Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONTROL CARD FOR 1 OR 2 12 Vcc MOTORS FOR OVERHEAD DOORS
•
MICROPROCESSOR-CONTROLLED LOGIC
•
INPUT STATUS LED'S
•
LINE INPUT FUSE
•
BUILT-IN FLASHING LIGHT CIRCUIT
•
433.92 MHz BUILT-IN RADIO RECEIVER
•
ENCODER SENSOR FOR OBSTACLE DETECTION AND SELF-LEARNING OF TRAVEL
•
DIAGNOSTICS OF MALFUNCTIONS SIGNALLED BY LED
ATTENTION:
-
do not use single cables (with one single wire), ex. telephone cables, in
order to avoid breakdowns of the line and false contacts;
-
do not re-use old pre-existing cables;
-
use only M-030000CC50 cable or equivalent.
TESTING
When you have completed the connection:
All the green LS LEDs must be on (each of them corresponds to a Normally Closed input).
The go off only when the controls to which they are associated are operated.
The red DL5 LS LED must be off (corresponding to the Normally Open OPEN/CLOSE input).
It only comes on when it is activated by the control to which it is associated.
TECHNICAL CHARACTERISTICS
Board power supply
Max motor 1 power DC
Max motor 2 power DC
Fast acting fuse for protection of input power supply 13.5 Vac (F1 - 5x20)
Fast acting fuse for motors protection (F2 - 5x20)
Fast acting fuse for protection of auxiliary circuits 18 V dc (F3 - 5x20)
Motor power supply circuits voltage
Auxiliary device circuits supply voltage
Logic circuits supply voltages
Operating temperature
DIAGNOSTICS LED
DL1
STEP BY STEP button red LED signal
DL2
CLOSE LIMIT SWITCH green LED
DL3
SENSITIVE EDGE green LED signal
DL4
Radio receiver programming red LED signal
DL5
ERRORS red LED signal
signal or pushbutton on hood
K996M
English
13,5 Vac - 50 Hz
50 W - 18 Vdc
50 W - 18 Vdc
F 16 A
F 10 A
F 3,15 A
18 Vdc
18 Vdc
5 Vdc
-20 °C ÷ +70 °C
15
Publicité
Table des Matières
