Installation; Checks; Earthing The Generator; Mounting - Simco-Ion CM Medium Notice D'utilisation

5. Installation

5.1. Checks

- Check that the generator is undamaged and that you have received the correct model.
- Check that the details on the packing slip correspond with the details shown on the product
received.
If you have any problems and/or if in doubt:
Please contact Simco-Ion or your regional agent.

5.2. Earthing the generator

Warning:
For personal protection and to ensure proper functioning, the following earth
connections must both be made:
 the fitted (yellow/green) earth wire to an earthed part of the machine.
 the mains connection (IEC connector).

5.3. Mounting

Warning:
- Do not install the generator in a dirty or damp environment or an environment where
chemicals or other corrosive agents are handled.
- The generator must be installed in a vibration-free environment.
1. Position the generator in a clearly visible and easily accessible location on or close to the
machine, as close as possible to the charging bar or electrode.
2. If required, the front panel can be rotated by 180° to make operation easier (see 5.4).
3. If you wish, secure the generator using the mounting materials supplied with the generator.
4. Connect the earth wire to an earthing point.
5. Connect the high voltage cables of the charging bars/electrodes.
6. Put the [0 / l] switch in the [0] position.
7. Plug the power cable into the Euro connector at the rear of the generator.
8. Plug the power cable into an earthed wall socket or connect the power cable via the machine.
5.4. Rotating the front panel by 180°
The front panel can be rotated by 180° as follows:
1. De-energise the generator (remove power cable).
2. Remove the cover.
3. Disconnect the 2 connectors of the front panel.
4. Unscrew both hexagon nuts on the front panel.
5. The front panel can now be taken off the generator and turned round.
6. Refasten the front panel with the 2 hexagon nuts, the plastic nut on the switch side and the
metal nut on the other side.
7. Re-connect the 2 connectors of the front panel. The 20-way cable with Pin 1 (marked wire) on
the side of the transparent 6-way flat cable, and the 12-way
cable with the grey and red/bleu wire on the side of the transparent 6-way flat cable.
CMMedium_UM_9752099010_NL_D_GB_F_V1_0 28