Marmitek KR22E Guide Utilisateur page 5

near this frequency will have influence on the range. When you use a FM10 Filter to
connect this device to the power line, the noise will be filtered.
4. The Marmitek X-10 protocol has several mechanism to avoid modules to be switched
on or off by other sources than your Marmitek X-10 Controllers. However, it is possi-
ble that the Marmitek X-10 signals are disturbed by e.g. baby phones which are in
TALK mode (continuous transmission). When these kind of signals are present on the
power line it is possible that the Marmitek X-10 signals will not come through.
5. The mains do not stop at the front door of your home. Everything that is attached to
mains nearby your home can have influence on Marmitek X-10 signals (e.g. heavy
machinery). If you think that your system is influenced by devices out of your house,
it is advisable to install FD10 Phase Coupler/Filter on each phase entering the house.
These filters will block signals coming into or going out of your house, but will also
match the impedance for the mains. Hereby make your house Marmitek X-10 com-
patible for these units. The FD10's will not only filter but will also couple the phases
(please see 1).
INSTRUCTIONS FOR USE KR22E REMOTE CONTROL
Congratulations on your purchase of a Marmitek X-10 KR22E key-ring remote control!
The KR22E is ideal for easy remote control of lighting and other equipment in and
around your home. The KR22E's small size makes it the ultimate portable controller. You
can take it with you wherever you go, for example, fitted to your key-ring. By pressing
the keys, you can switch up to 4 addresses on and off. With the dimmer keys, you can
adjust lighting or control sunshades (when used in combination with the SW10). The
KR22E is designed to work in combination with a RF Transceiver, such as the TM13,
IRRF7243 or a Marmitek X-10 alarm system. When used in combination with the CM11
computer interface, the KR22E can steer up to 8 macros.
INSTALLATION
In the default state the KR22E is set to House Code A. The upper buttons will control
Unit Code 1, the next buttons will control Unit Code 2, 3 and 4. The lower buttons are
for Bright and Dim.
To change the House Code
1. Press and hold the first (top) ON button. The red LED blinks once. 3 seconds later, the
LED blinks the current setting: 1 blink for House Code A, 2 blinks for B ... 16 blinks
for P.
2. Release the first (top) ON button.
3. Press and release the first (top) ON button the appropriate number of times for the
House Code you want to set. Once for A, twice for B, etc. The LED blinks for each
press. IMPORTANT: Hold the button on your last press. 3 seconds later, the LED blinks
KR22E
™
5