MRA 10634 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
4 Rubber washers 16 x 4.5 x 4mm
4 Edge protection strip, sleeves
Fitting the screen to the motorcycle:
1. Position the motorcycle on a level surface.
2. Unscrew the fastening screws and remove the windshield.
3. Insert these screws into the new windshield and mount the enclosed
rubber spacers onto the screws from the inside.
4. Position the windshield on the motorcycle and screw the screws into the
fastening holes.
5. Pull the edge protection strip over the rear, exposed area of the screen. Cut
off the excess as necessary.
6. Push the clamping ferrules over the ends of the edge protection strip and
squeeze them lightly with a pair of pliers so that the edge protection strip is
clamped.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Kawasaki ER6N 2012-
Article No..
--- Allen key 4mm
10634
---
3
Required tools