Bycool COMPACT 1.4 Instructions De Montage page 21

COMPACT 1.4
Place console and centre equipment in the
13
most convenient place of cabin roof. Once
centred, remove console for later installation.
Fasten supports tightening nuts until outside
14
EPDM joint of equipment is compressed,
between 3 and 6 mm;
Important: To avoid water from filtering
inside cabin, check EPDM joint tightening
with unit base, as indicated on diagram.
14
3-6mm.
Cabin roof
Fasten selflocked nut until
EPDM gasket is compressed
between 3 and 6 mm.
Tighten (4) M8 nuts to support and (4) to
15
Unit base.
EPDM gasket
10 mm*
(*) (approx. after tightening)
Air conditioning for vehicles
13
Base
EPDM Joint
21
Check compression
thickness using a
tape measure in the
four corners.
EPDM gasket
EN
14
15