Bycool COMPACT 1.4 Instructions De Montage page 17

COMPACT 1.4
OUTSIDE CABIN:
5
Position Compact in sun hatch hole.
Caution! When positioning the unit above
the hatch gap, check that the wastewater
run-offs are not blocked by the EPDM
seal.
To place the foam rubber ducting remaining
6
at the softer part of the base.
INSIDE CABIN:
7
Screw about 5 mm (4) 8/125x100 or 120
mm studs, the exact measure is chosen
after the fastening supports have been
presented and taking into account that
studs must stick out of lower part about 20
mm.
Following this order:
8
- Ø 7 plane rubber wash
- plane ruber wash wide wing diameter 8
- nut M8
- plane washer diameter 8 wide wing
Air conditioning for vehicles
6
7
Unit base
7
plane ruber wash
Ø 7 plane
wide wing Ø 8
rubber wash
8
17
Sun hatch
5 mm
Stud
Bracket
20 mm
Nut M8
EN
5
7
plane washer Ø8
wide wing