Possible Settings - Krups ESPRESSO AUTOMATIC EA84 Série Manuel D'utilisation

IFU_KR_EA84_NAFTA_EA84 25/10/13 11:01 Page16
When the steam nozzle is hot, handle using the plastic part only. Fig. 13.
To remove any trace of milk from the steam nozzle, place a container under the nozzle and
press "hot water" for a few seconds.
The steam nozzle can be disassembled for thorough cleaning. Fig. 14.
Clean with water and a dishwashing soap using a brush. Rinse and dry. Fig. 15.
Before reassembling the steam nozzle, make sure that the air holes are not clogged with milk
residue. Unclog with the needle provided if necessary. Fig. 16.
SUPER CAPPUCCINO ACCESSORY (available depending on model)
Important: we recommend that you use very fresh, very cold pasteurised milk, recently
!
opened. Unpasteurised milk does not produce the best results.
The super cappuccino accessory helps the preparation of a cappuccino or latte.
Preparing the appliance:
Connect the milk suction pipe to the super cappuccino accessory, on the unbevelled side. The
inlet must not be twisted.
Fit the accessory on the steam outlet after having removed the steam nozzle
Enter the bevelled end of the suction pipe into a container filled with very fresh, very cold milk.
Fig. 17.
Place a cup under the super cappuccino accessory.
Recipe stage 1:
Select the cappuccino ( ) or caffè latte ( ) position on the super cappuccino accessory.
Press "steam" to start the pre-heating process.

Possible settings

You can change the steaming time using the – and + buttons located to the left and right of the
symbols.
Press the "OK" button on the touch screen to launch the preparation.
Important: press any button to stop the steam function. Caution, the cycle does not stop
!
immediately.
Recipe stage 2:
Place a cup under the coffee outlet and start a coffee/espresso cycle. Fig. 18. (See chapter:
Preparing drinks using coffee beans).
Rinsing the accessory:
To ensure that the accessory functions properly, rinse with water after each use. Your appliance
will not ask you to do this. Carry out a steam cycle with a container filled with water in order to
clean the inside of the steam nozzle. Fig. 19.
To do this, you can also use the KRUPS XS9000 liquid cleaner which is available as an accessory.
Maintenance and cleaning:
Remove the super cappuccino accessory and clean the parts using dishwasher soap and a brush.
Please look at Fig. 20 to make sure you clean all the parts, including the circled part on the picture.
This process is very important to avoid any clogging issue The hole in the metal part should not
be allowed to become blocked.
16