Bticino U1451A Notice D'emploi page 8

3
Connect the batteries to the power
supply terminals (3) using the
correct wire complete with
protection with fuse.
Be careful with the battery
polarity during the
connection.
Please note: when the LED
(5) flashes, it means that
the battery is dead.
The following chart shows the maximum current supplied to the devices, according to the battery
installed and to the level of autonomy required.
However, the maximum absorption must not exceed 2 A.
lifetime when
there is
a power cut
( ) In these cases the system respects level 1 of standard IEC 79-2.
*
5
Install the container closing
covers
24 h
15 h
8 h
If you want to protect the battery compartment,
connect the contact on the container item
F115/8B (4) to a tamper line.
type of battery installed
7,2 Ah
12 Ah
500 mA ( * )
300 mA ( * )
800 mA
480 mA
900 mA 1,5 A
4
24 Ah
1 A
1,6 A
2 A
4
5